[CentOS-devel] skge or sk98lin drivers with CentOS5 ?
ajb.stxsl at googlemail.com
Tue Jun 16 10:56:28 UTC 2009
On 15/06/2009, James Pearson <james-p at moving-picture.com> wrote:
> I've just installed CentOS 5.3 on a workstation with an on-board
> 'Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller'
What is the Vendor:Device ID pairing for that card?
> Anaconda used the skge.ko module for the install (over NFS), but once
> installed, it uses the sk98lin.ko driver
> However, /etc/modprobe.conf has the line:
> alias eth0 skge
If it is working, leave it alone. If you have issues, please check the
kmod-sk98lin package that is available from ELRepo (http://elrpo.org).
This topic is more appropriate for the general mailing list or the fora.
More information about the CentOS-devel