[CentOS-virt] Can I bridge a bonded and vlan tagged interface directly to a guest?
Coert Waagmeester
lgroups at waagmeester.co.za
Mon Aug 3 08:17:55 UTC 2009
On Fri, 2009-07-31 at 11:08 -0400, David Knierim wrote:
> I am running CentOS 5.3 x86_64 as my dom0 and CentOS 5.3 on my domU's.
> On the dom0, I have two interfaces that are bonded and have tagged
> VLANs. I can get the networks to the domU's by creating a bridge for
> each of the VLANS (bond0.3, bond0.4, etc). On the domU, the
> interfaces show up as eth0, eth1, etc.
>
> Is there a way to set up the network on the dom0 so my domU's see a
> single interface with tagged VLAN support??
>
> Thanks!
> David
> _______________________________________________
> CentOS-virt mailing list
> CentOS-virt at centos.org
> http://lists.centos.org/mailman/listinfo/centos-virt
Hello David,
Sorry this is not an answer to your question, but how did you set up the
bonds with xen?
I tried doing the same, and did not win....
Regards,
Coert
More information about the CentOS-virt
mailing list