[CentOS-virt] Is kvm ready for prime time?
Lars Hecking
lhecking at users.sourceforge.net
Wed Jun 9 12:47:59 EDT 2010
> Try setting up vnc and use a vnc viewer to administer the guest.
That worked. Thanks!
Unfortunately, it seems the interface bridging doesn't seem to work, the vm
says "no network link detected on eth0". This is the ifconfig on the host:
br0 Link encap:Ethernet HWaddr 00:14:5E:6B:B9:BE
inet addr:10.2.3.4 Bcast:10.2.3.255 Mask:255.255.255.0
inet6 addr: fe80::214:5eff:fe6b:b9be/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:95936 errors:0 dropped:0 overruns:0 frame:0
TX packets:19855 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:50289551 (47.9 MiB) TX bytes:32322314 (30.8 MiB)
eth0 Link encap:Ethernet HWaddr 00:14:5E:6B:B9:BE
inet6 addr: fe80::214:5eff:fe6b:b9be/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:104793 errors:0 dropped:0 overruns:0 frame:0
TX packets:38325 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:52621784 (50.1 MiB) TX bytes:33702340 (32.1 MiB)
Interrupt:169 Memory:d0200000-d0210000
> IIRC you're connected to the serial console of the guest, so if your
> software isn't setup to use the serial port nothing will happen (or
> output only garbage).
I see. Will look at this at a later point.
---------------------------------------------------------------
This message and any attachments may contain Cypress (or its
subsidiaries) confidential information. If it has been received
in error, please advise the sender and immediately delete this
message.
---------------------------------------------------------------
More information about the CentOS-virt
mailing list