<div dir="ltr"><br><div class="gmail_extra"><br><div class="gmail_quote">On Wed, May 17, 2017 at 3:43 AM, PJ Welsh <span dir="ltr"><<a href="mailto:pjwelsh@gmail.com" target="_blank">pjwelsh@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left-width:1px;border-left-style:solid;border-left-color:rgb(204,204,204);padding-left:1ex"><div dir="ltr"><div class="gmail_extra"><div class="gmail_quote"><span class="gmail-">On Tue, May 16, 2017 at 10:26 PM, Jerry <span dir="ltr"><<a href="mailto:jerryubi@gmail.com" target="_blank">jerryubi@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left-width:1px;border-left-style:solid;border-left-color:rgb(204,204,204);padding-left:1ex"><div dir="ltr">Howdy,<div><br></div><div>I recently went through a frustrating experience trying to get Xen 4 running on a CentOS 7 system.  After a fresh install, fully updating the system, rebooting, then trying to install Xen4CentOS it would fail to boot into the 4.9 kernel, sitting there with a blinking cursor indefinitely.</div></div></blockquote></span><div>...</div><div> </div></div>Check the BIOS to see if Hyperthreading is disabled. If so, enable it. I had some Dell server (Dell R710s and R610s) that I finally figured out would not boot like you describe when HT is off for some reason.<span class="gmail-HOEnZb"><font color="#888888"><div>PJ</div></font></span></div></div></blockquote><div><br></div><div>I found what my issue was with it not booting, when the 4.9 kernel was installed it didn't include the mpt3sas driver.  I posted the solution to the mailing list earlier with the subject:</div><div><br></div><div>4.9 kernel fails to boot because it didn't have the mpt3sas module<br></div><div><br></div><div>This post is just asking what the purpose of console=hvc0 is.</div><div><br></div><div>Thanks,</div><div>Jerry</div></div></div></div>