[CentOS] data overrun on SCSI drive

Bowie Bailey

Bowie_Bailey at BUC.com
Tue May 17 15:48:39 UTC 2005


I have a system that I just installed with CentOS 4.0.  It is an HP
NetServer E 60 with dual CPUs and 1G RAM.  There is an Adaptec AIC-7895
built into the motherboard.

On bootup, I get this:

(scsi0:A:1): 11.626MB/s transfers (5.813MHz, offset 8, 16bit)
(scsi0:A:1:0): data overrun detected in Data-in phase.  Tag == 0x2.
(scsi0:A:1:0): Have seen Data Phase.  Length = 255.  NumSGs = 1.
sg[0] - Addr 0x03ace40 : Length 255
(scsi0:A:1:0): data overrun detected in Data-in phase.  Tag == 0x3.
(scsi0:A:1:0): Have seen Data Phase.  Length = 255.  NumSGs = 1.
sg[0] - Addr 0x03ace40 : Length 255
(scsi0:A:1:0): data overrun detected in Data-in phase.  Tag == 0x2.
(scsi0:A:1:0): Have seen Data Phase.  Length = 255.  NumSGs = 1.
sg[0] - Addr 0x03ace40 : Length 255
scsi scan: 255 byte inquiry failed with code 458752.  Consider
BLIST_INQUIRY_36 for this device
  Vendor: WDIGTL    Model: WDE18300 ULTRA2   Rev: 1.30
  Type:   Direct-Access                      ANSI SCSI revision: 02
scsi0:A:1:0: Tagged Queuing enabled.  Depth 4
SCSI device sdb: 35761710 512-byte hdwr sectors (18310 MB)
SCSI device sdb: drive cache: write back
 sdb: sdb1
Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0

How do I use BLIST_INQUIRY_36?  Is there anything else I can try to fix this
error?

Also, is there a searchable archive for this list?

Bowie



More information about the CentOS mailing list