[CentOS] After install centos does not find hardrives (SATA)
Will McDonald
wmcdonald at gmail.comWed Feb 15 23:25:03 UTC 2006
- Previous message: [CentOS] After install centos does not find hardrives (SATA)
- Next message: [CentOS] After install centos does not find hardrives (SATA)
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
On 15/02/06, Nathan <lists at netdigix.com> wrote: > Hi we installed centos on a Intel server board with LSI rad (no raid configured > for the lsi). in Centos it sees both drives so we software raid them and the > installation goes well and finishes properly. The problem is when the server > reboots it can no longer see the hard drives and no just boots to a low level > diagnostic shell. Any ideas? Is the diagnostic shell single user mode? That would lead me to think the kernel's bootstrapping to some extent at least and seeing the disks otherwise where that shell coming from? Unless it's the grub shell? What does ... # fdisk -l ... list if it runs? Can you boot into rescue mode from an install CD, does it find the installed OS and allow you to chroot into it? If not does fdisk see the disks at this level? If it's not getting further than greb then it's likely there's no support for the disk controller in the initrd installed in boot but there is in the one used off the CD. Will.
- Previous message: [CentOS] After install centos does not find hardrives (SATA)
- Next message: [CentOS] After install centos does not find hardrives (SATA)
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list