[CentOS] Cisco 2801 Tunnel1 Mrtg graph

Dear All Salam,

Please go through the cfg file:

Target[IP_Tu1]: Tunnel1:community at IP:
SetEnv[IP_Tu1]: MRTG_INT_IP="IP" MRTG_INT_DESCR="Tunnel1"
MaxBytes[IP_Tu1]: 1125
Title[IP_Tu1]: Tunnel1 -- yourdomain.com
PageTop[IP_Tu1]: <H1>Tunnel1 -- yourdomain.com</H1>
 <TABLE>
   <TR><TD>System:</TD>     <TD>yourdomain.com in </TD></TR>
   <TR><TD>Maintainer:</TD> <TD></TD></TR>
   <TR><TD>Description:</TD><TD>Tunnel1  </TD></TR>
   <TR><TD>ifType:</TD>     <TD>Encapsulation Interface (131)</TD></TR>
   <TR><TD>ifName:</TD>     <TD>Tu1</TD></TR>
   <TR><TD>Max Speed:</TD>  <TD>1125.0 Bytes/s</TD></TR>
   <TR><TD>Ip:</TD>         <TD>yourdomain.com</TD></TR>
 </TABLE>

Here, the office traffic is on Tunnel1 interface, when i run mrtg the graph
is displaying but
traffic is not shown.

please help in this regard.

Regards,

Umair Shakil
ETD
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.centos.org/pipermail/centos/attachments/20080408/2d1ac878/attachment.html>