[CentOS] Re: Problem with Bonding Driver

Art Age Software artagesw at gmail.com
Sat Jul 5 16:45:16 UTC 2008


>>Hi,
>>
>>could you describe in more detail?
>>What exactly is ignored? The options do not look much different.

As I said, I am trying to set a different primary interface for each
bond: eth0 for bond0, and eth2 for bond1.

>>Did you try without renaming? I do not use it, but it works nonetheless:
>>alias bond0 bonding
>>options bond0 mode=2
>>alias bond1 bonding
>>options bond1 mode=2

You are setting identical options for both bonds. This masks the fact
that your second options line is ignored and essentially does nothing.
Try changing an option on bond1 (eg. set a different mode or a
different miimon value), and I think you will see that it is ignored.

On Fri, Jul 4, 2008 at 1:11 PM, Art Age Software <artagesw at gmail.com> wrote:
> Hi,
>
> I've using linux bonding in active-backup mode to combine two pairs of
> GigE NICs (eth0/eth1, eth2/eth3) into two logical bonds (bond0/bond1).
> All is working fine. However, I would like to specify a primary
> interface for each bond. This means I need to specify different
> options to the bonding module for each bond. I have tried every
> conceivable incantation of options and cannot get the kernel to
> recognize the second set of options.
>
> Initially, my modprobe.conf looked like this:
>
> alias bond0 bonding
> alias bond1 bonding
> options bonding mode=active-backup miimon=100 max_bonds=2
>
> What I am trying to achieve should be possible by changing
> modprobe.conf to this:
>
> alias bond0 bonding
> options bond0 -o bond0 miimon=100 mode=active-backup primary=eth0
> alias bond1 bonding
> options bond1 -o bond1 miimon=100 mode=active-backup primary=eth2
>
> But this results in fatal errors while bringing up the bonding interfaces.
>
> Changing to this eliminates the errors, but bond1 ignores the different options:
>
> alias bond0 bonding
> options bond0 -o bond0 miimon=100 mode=active-backup primary=eth0 max_bonds=1
> alias bond1 bonding
> options bond1 -o bond1 miimon=100 mode=active-backup primary=eth2 max_bonds=1
>
> I have tried many other combinations as well:
>
> install bond1 /sbin/modprobe --ignore-install bonding -o bond1
> mode=active-backup primary=eth2
>
> Nothing works.
>
> I also came across this note in the bonding docs:
>
> "NOTE: It has been observed that some Red Hat supplied kernels are
> apparently unable to rename modules at load time (the "-o bond1"
> part). Attempts to pass that option to modprobe will produce an
> "Operation not permitted" error. This has been reported on some Fedora
> Core kernels, and has been seen on RHEL 4 as well. On kernels
> exhibiting this problem, it will be impossible to configure multiple
> bonds with differing parameters."
>
> I have seen that error as well with certain combinations of options in
> my modprobe.conf.
>
> Am I simply out of luck here? Does anyone know of a solution?
>
> Thanks.
>



More information about the CentOS mailing list