[CentOS] need advise on protect base and priorities plugin
ceejay9492002 at yahoo.com
Thu Jun 19 13:19:11 UTC 2008
----- Original Message ----
From: Johnny Hughes <johnny at centos.org>
To: CentOS mailing list <centos at centos.org>
Sent: Thursday, June 19, 2008 20:54:09
Subject: Re: [CentOS] need advise on protect base and priorities plugin
ceejay cervantes wrote:
> Is it not ok to use both plugins at the same time? I have read from the wiki page of centos that you must use only either protect base or priorities plugin. I have been using the the config file below for months and did not encounter any problems. I used priority=1 and protect=1 on base and updates (addons,extras protect=1 ; set no priorities) for the CentOS-Base repo and on the rpmforge repo I used protect=0 and did not set any priority. Should I enable only one (protect base or priorities) and not both? Thanks.
Just for the record, basically protectbase is priorities with only 2
settings (0 and 1)
So, if you have both installed, protectbase will override the priorities.
So, you should pick one or the other, but not both.
Send instant messages to your online friends http://uk.messenger.yahoo.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the CentOS