[CentOS] E1000 eth1 link flakiness - causes??
Frank Cox
theatre at sasktel.net
Mon Dec 27 22:45:55 UTC 2010
On Mon, 27 Dec 2010 17:37:50 -0500
E Westphal wrote:
> I've tried all the obvious things. Cables, router ports, rebooting etc.
> It's quite strange. From a cold bootup, it's fine. Then about 45 minutes
> later it starts to act up. None of the obvious things seem to help.
> Then, about 90 minutes after bootup, everything is fine again! Rock
> solid! Ethtool and anything else I've tried fails to yield any hints,
> thus my question to all of you.
It sounds very much like a hardware issue, more specifically a cold solder
joint whose properties change as the unit warms up.
--
MELVILLE THEATRE ~ Melville Sask ~ www.melvilletheatre.com
www.creekfm.com - FIFTY THOUSAND WATTS of POW WOW POWER!
More information about the CentOS
mailing list