[CentOS] Software RAID1 with CentOS-6.2

Kahlil Hodgson kahlil.hodgson at dealmax.com.au
Wed Feb 29 03:21:30 UTC 2012


Hi Ellen,

On Tue, 2012-02-28 at 18:59 -0700, Ellen Shull wrote:
> On Tue, Feb 28, 2012 at 5:27 PM, Kahlil Hodgson
> <kahlil.hodgson at dealmax.com.au> wrote:
> > Now I start to get I/O errors on printed on the console.  Run 'mdadm -D
> > /dev/md1' and see the array is degraded and /dev/sdb2 has been marked as
> > faulty.
> 
> I had a problem like this once.  In a heterogeneous array of 80 GB
> PATA drives (it was a while ago), the one WD drive kept dropping out
> like this.  WD's diagnostic tool showed a problem, so I RMA'ed the
> drive...  only to discover the replacement did the same thing on the
> system, but checked out just fine on a different system.  Turned out
> to be a combination of a power supply with less-than-stellar
> regulation (go Enermax...) and the WD was particularly sensitive to
> it; nothing else in the system seemed to be affected  Replacing the
> power supply finally eliminated the issue.

Hmm ... that could be the problem.  Power supply is the only component
that is not brand new.  Just swapped it out for a spare.  Will see how
that goes over the next few hours.

Cheers!

Kal

-- 
Kahlil (Kal) Hodgson                       GPG: C9A02289
Head of Technology                         (m) +61 (0) 4 2573 0382
DealMax Pty Ltd                            (w) +61 (0) 3 9008 5281

Suite 1005
401 Docklands Drive
Docklands VIC 3008 Australia

"All parts should go together without forcing.  You must remember that
the parts you are reassembling were disassembled by you.  Therefore,
if you can't get them together again, there must be a reason.  By all
means, do not use a hammer."  -- IBM maintenance manual, 1925







More information about the CentOS mailing list