<br><font size=2 face="sans-serif">I really hope someone has a clue on
this one.... :)</font>
<br>
<br><font size=2 face="sans-serif">I've got a 2.2TB array mounted on a
3ware 9500 controller. I installed it last week ensuring that LBA was enabled
and using gpt with parted to get the full size available on one array.
I also think I chose reiserfs for the array. We then moved ALOT of data
to the array.</font>
<br>
<br><font size=2 face="sans-serif">Problem now is that after a reboot LBA
doesn't seem to be in effect. From dmesg:</font>
<br>
<br><font size=2 face="sans-serif">sdc : very big device. try to use READ
CAPACITY(16).</font>
<br><font size=2 face="sans-serif">SCSI device sdc: 4374845440 512-byte
hdwr sectors (2239921 MB)</font>
<br><font size=2 face="sans-serif">SCSI device sdc: drive cache: none</font>
<br><font size=2 face="sans-serif">sdc : very big device. try to use READ
CAPACITY(16).</font>
<br><font size=2 face="sans-serif">SCSI device sdc: 4374845440 512-byte
hdwr sectors (2239921 MB)</font>
<br><font size=2 face="sans-serif">SCSI device sdc: drive cache: none</font>
<br><font size=2 face="sans-serif"> sdc: sdc1</font>
<br><font size=2 face="sans-serif">Attached scsi disk sdc at scsi1, channel
0, id 0, lun 0</font>
<br><font size=2 face="sans-serif">Attached scsi generic sg0 at scsi0,
channel 0, id 0, lun 0,  type 0</font>
<br><font size=2 face="sans-serif">Attached scsi generic sg1 at scsi0,
channel 0, id 7, lun 0,  type 0</font>
<br><font size=2 face="sans-serif">Attached scsi generic sg2 at scsi1,
channel 0, id 0, lun 0,  type 0</font>
<br>
<br><font size=2 face="sans-serif">I can no longer mount sdc1; the error
is the usual invalid superblock. parted does however list the correct size
and filesystem.</font>
<br>
<br><font size=2 face="sans-serif">Any tips on how I can get the array
mounted again? And what might have changed since last boot? :) I've rolled
my own kernel to get reiser support, but I haven't recompiled or done any
changes...</font>
<br>
<br><font size=2 face="sans-serif">Regards,</font>
<br><font size=2 face="sans-serif">Harald</font>
<br>