I am starting on a fresh install of the 1611 Cubietruck image.  This time I am running on a Cubietruck, not a Cubieboard2.

I have the cubietruck uboot on a mSD card and the image installed on a Kingston 240Gb SSD drive.

I boot up, log in with root with the default password.  All I do is change /boot/extlinux/extlinux.conf with:

sed -i -e "s/enforcing=0/enforcing=1/w /dev/stdout" /boot/extlinux/extlinux.conf

Note that https://wiki.centos.org/SpecialInterestGroup/AltArch/Arm32 is wrong saying:

If you want to switch to enforcing mode, you'll have so to first modify the following files /etc/sysconfig/selinux : change from "permissive" to "enforcing"

• rpi2/rpi3 : /boot/cmdline.txt: change "enforce=0" to "enforcing=1"
• other image/board[s]: /boot/extlinux/extlinux.conf : change the "enforce=0" to "enforce=1"

It is enforcing=0 on the Cubietruck image.  Then:

touch /.autorelabel

and

reboot

I get the log message:

[   18.453896] brcmfmac: brcmf_sdio_htclk: HT Avail timeout (1000000): clkctl 0x50

*** Warning -- SELinux targeted policy relabel is required.
*** Relabeling could take a very long time, depending on file
*** system size and speed of hard drives.
[   54.365478] random: nonblocking pool is initialized
Warning: Skipping the following R/O filesystems:
/sys/fs/cgroup


Then after some time, it goes through a shutdown, reboots and comes back to this state.  Then reboots again.  I have tried this twice.

Next I will try on my Cubieboard2, that I will have to take down from its testing position for this test.  If it still fails, I will try a HD.  These commands have worked for my on the C2 with a HD and a mSD card.  I don't recall if I have tried them on a CT.

But any thoughts are appreciated!

thanks