On 8/5/2015 11:27 AM, m.roth@5-cent.us wrote:
Bowie Bailey wrote:
I am trying to upgrade my system from 500GB drives to 1TB. I was able to partition and sync the raid devices, but I cannot get the new drive to boot.
This is an old system with only IDE ports. There is an added Highpoint raid card which is used only for the two extra IDE ports. I have upgraded it with a 1TB SATA drive and an IDE-SATA adapter. I did not have any problems with the system recognizing the drive or adding it to the mdraid. A short SMART test shows no errors.
<snip> Trying to get your configuration clear in my mind - the drives are 1TB IDE, and they're attached to the m/b, or to the Hpt RAID card?
Also, did you update the system? New kernel? If so, is the RAID card recognized (we've got a Hpt RocketRaid card in a CentOS 6 system, and we're *finally* replacing it with an LSI (once it comes in), because Hpt does not care about old cards, and I had to find the source code, and then hack it to compile it for the new kernel, and have had to recompile for the new kernels we've installed....
It was originally a pair of 500GB IDE drives in an mdraid mirror configuration. Right now, I have removed one 500GB drive and replaced it with a 1TB SATA drive with an IDE-SATA adapter. Both drives are connected to the Highpoint card and apparently working fine other than the boot-up problem.
I was considering adding an SATA card to the system, but I didn't want to deal with finding drivers for a card old enough to work with this system (32-bit PCI).
I have not done any updates to the system in quite some time.