jtj and Eero, thank you for replying.
please excuse delay in replying. see *additions* at end.
On 07/14/2016 03:40 AM, Eero Volotinen wrote:
2016-07-14 11:36 GMT+03:00 Jose Maria Terry Jimenez jtj@tssystems.net:
El 14/7/16 a las 9:01, ge lignored escribió:
greetings to one and all.
a new iso burn w/ centos 6.8 failed to boot on a 686 32 bit mid tower
box,
but will boot a 32 bit laptop, so i dropped back to 6.7 which did boot.
after install with centos 6.7, attempt to upgrade fails with 'repolist
0'.
all desire repo files have enable = 1.
searched thru past 4 yrs of personal archives, nothing found related to 'repolist 0'.
ran web search for 'repolist 0' and 'repolist = 0' with all hits related to repo files having 'enable = 0'.
any suggestions/ideas/clues as to solution of problem greatly
appreciated.
Hello
Never seen this but i'd try
yum repolist all
fails with 'repolist: 0'.
Lists the enabled repos?
fails with 'repolist: 0'.
Did you tried
yum clean all
Before the upgrade?
fails with 'repolist: 0'
I think this happens in RHEL if you have no active suscription, but not applicable to CentOS.
do not have rhel installed so can not test.
You can also add yum -v or -vv to debug issue more.
Eero
both fail with 'repolist: 0'.
*additions*
made a file by file comparison between 2 systems of yum directories, both have same files. i did not go thru /lib and /var files.
side-note: tried to add this gmail account to thunderbird, ran into problems with gmail. next replies may be with a diff account setup using thunderbird.
jtj and Eero, i thank you again for replying. much appreciated.