I installed CentOS-5 on a test machine, a P4 1.8 Ghz Compaq Evo D510 series. This was a clean install onto a new disk drive and everything went well. After updating with YUM and installing Postgresql, Rails for Ruby, Firefox-2 and Thunderbird I shutdown and restarted the system several times without incident.
I then pulled the CD-ROM and replaced it with an LG-DVD DVD-RAM/RW device. I also swapped the PS/2 Kb and mouse for USB versions. When I rebooted the system I entered the bios setup and reconfigured for the new device. However, subsequently, Centos bootup has now entered an endless loop. Pluse neither the USB nor the PS/2 kb seem to work after a certain point.
On Centos-4 I recall doing exactly the same thing and all that happened was that Kudzu ran during the boot procedure, prompted for the configuration changes and everything went on swimingly. I just verified this behaviour by swapping in a CentOS-4.5 disk on this machine and Kudzu came up, reported on all the config changes, accepted the responses and it booted with the DVD and USB devices installed
What is happening in CentOS-5? Is there no hardware probe at startup? Is there some switch that I need to set? I can boot from the CD-ROM on this machine using the LG-DVD but not from the hard drive. Switching back to the original CD-ROM device did not alleviate the problem either so I am at a loss as to what is happening.
As I am a digest subscriber the favour of a direct copy of any reply to the list is requested.
Sincerely,