Hi there, I have a system with the following:
# fdisk -l
Disk /dev/sda: 80.0 GB, 80000000000 bytes 255 heads, 63 sectors/track, 9726 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System /dev/sda1 * 1 13 104391 83 Linux /dev/sda2 14 9471 75971385 83 Linux /dev/sda3 9472 9726 2048287+ 82 Linux swap / Solaris
Disk /dev/sdb: 1000.2 GB, 1000204886016 bytes 255 heads, 63 sectors/track, 121601 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System /dev/sdb1 * 1 121601 976760001 fd Linux raid autodetect
Disk /dev/sdd: 1000.2 GB, 1000204886016 bytes 255 heads, 63 sectors/track, 121601 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System /dev/sdd1 * 1 121601 976760001 fd Linux raid autodetect
Disk /dev/md0: 1000.2 GB, 1000202174464 bytes 2 heads, 4 sectors/track, 244189984 cylinders Units = cylinders of 8 * 512 = 4096 bytes
Disk /dev/md0 doesn't contain a valid partition table
Now I just added a new hard drive (sdc).
I was wondering how to go about (if possible) to add this drive to my existing partitions with LVM.
Now I never setup this system (Another person had), and if i am reading the above right, it appears as though they did not use LVM for the raid.
The system has the OS on a standalone drive, the home folder is on the two raided drives. I was hoping to extend my home folder to take advantage of my new drive.
Recommendations?
d