I've always known the config file to be /etc/sysconfig/network-scripts/ifcfg-eth0
Sample: DEVICE=eth0 BOOTPROTO=static ONBOOT=yes TYPE=Ethernet IPADDR=xxx.xxx.xxx.xxx NETMASK=255.255.255.xxx DEFROUTE=yes IPV4_FAILURE_FATAL=yes IPV6INIT=yes NETWORKING_IPV6=yes NAME="System eth0" HWADDR=xx:xx:xx:xx:xx:xx
IP addresses changed to protect the guilty :)
Hopes this helps...
Richard
-----Original Message----- From: centos-bounces@centos.org [mailto:centos-bounces@centos.org] On Behalf Of Eric Falbe Sent: Thursday, May 15, 2014 3:47 PM To: CentOS mailing list Subject: Re: [CentOS] Set static IP
Not sure if the problem, but BOOTPROTO=static should be BOOTPROTO=none. Eric Falbe On 05/15, Joseph Hesse wrote:
Hello, I want my CentOS 6.5 computer to have a static IP. Currently I get the IP I want because I have my router assign it on the basis of mac address. I placed the following file as: /etc/sysconfig/networking-scripts/eth0
DEVICE="eth0" BOOTPROTO=static HWADDR=00:1F:D0:9E:AE:67 ONBOOT=yes TYPE=Ethernet USERCTL=no IPV6INIT=no PEERDNS=yes NETMASK=255.255.255.0 IPADDR=192.168.0.99 GATEWAY=192.168.0.1 NM_CONTROLLED=no
I also disabled Network Manager with chkconfig.
It didn't work. When I rebooted I had no IP address for eth0. Should I leave all the other scripts in /etc/sysconfig/networking-scripts unchanged?
Suggestions would be appreciated.
Thank you, Joe _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
_______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos