-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
I am running Centos 4.3 with the 2.6.9-42.EL.jwltest.156 kernel (to get the skge module) The card is recognized, and I can see traffic when I utlilize wireshark in promiscuous mode including attempts at responding to ARP requests.
9.608260 DellPcba_b8:d7:63 -> Broadcast ARP Who has 172.20.15.25? Tell 172.20.15.27 9.608281 D-Link_87:55:06 -> DellPcba_b8:d7:63 ARP 172.20.15.25 is at 00:15:e9:87:55:06
However, no icmp traffic passes, and the pinging host acts as if it can't find the address. Even after supposedly responding to the ARP traffic it still shows no TX packets.
ifconfig output: eth2 Link encap:Ethernet HWaddr 00:15:E9:87:55:06 inet addr:172.20.15.25 Bcast:172.20.15.255 Mask:255.255.255.0 inet6 addr: fe80::215:e9ff:fe87:5506/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:520 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:50348 (49.1 KiB) TX bytes:0 (0.0 b) Interrupt:11
dmesg | grep eth2 output: skge eth2: enabling interface skge eth2: Link is up at 1000 Mbps, full duplex, flow control none eth2: no IPv6 routers present device eth2 entered promiscuous mode device eth2 left promiscuous mode (promiscuous mode is a result of using tshark)
[root@jupiter2 ~]# route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 68.XXX.XXX.0 * 255.255.255.128 U 0 0 0 eth0 172.20.15.0 * 255.255.255.0 U 0 0 0 eth2 default 68.XXX.XXX.XXX 0.0.0.0 UG 0 0 0 eth0
Any suggestions welcome.
Thanks,
David Nalley