Try text installation, I used to have similar problem with graphics installation.
Mirek
Dne 31.7.2019 v 15:32 John Chludzinski napsal(a):
After finally completing and trying to reboot, the machine goes into "Emergency Mode" and asks that I log in as root. That fails and the machine becomes completely unresponsive.
I tried the minimum install and got the same result.
Hard to diagnose an unresponsive machine.
On Tue, Jul 30, 2019 at 4:54 PM isdtor isdtor@gmail.com wrote:
Pete Biggs writes:
On Tue, 2019-07-30 at 13:24 -0400, John Chludzinski wrote:
I've been doing a CentOS 7.6.1810 net-install since last night. The
machine
seems ok but has been stuck with "performing post-installation setup
tasks"
for hours. This is an old Dell T5400 box, so it isn't blazing fast but
...
Is there a way to pull up its skirt (so to speak) and check/monitor the installation activity while installing it? Having already started the installation?
Yes, there are shells running on the alternative consoles, so if you are doing a GUI install then do Ctrl-Alt-F1 to get to the text console
- that console is the one running the install and may have some error
messages. Do Alt-F2 from there to get to a shell prompt with root privileges, Alt-F3 for the anaconda log, Alt-F4 for the storage log, Alt-F5 for other log messages and Alt-F6 to get back to the GUI install.
It is my experience too that starting with CentOS 7, "post-installation setup tasks" take up an inproportionate amount of time during. All I was able to find out was that the kickstart %post section was not the culprit.
It would be nice to have some detailed documentation what these post-installation tasks actually are. ISTR a lot of dracut this and that showing up in top.