On 6/20/2012 10:27 AM, Gregory P. Ennis wrote:
Gregory P. Ennis wrote:
<snip> > I have been chasing a problem with a pci-e TrendNet(TEG-ECTX) gigabit > card. After adding the card to a machine with a new Centos 6.2 install > and naming it 'eth4' it works well for 6 to 12 hours and then fails. > The failure is characterized by dropping its connection speed from 1000 > to 100 while not allowing any data to flow in or out. When this happens > a shutdown and reboot does not solve the problem, but shutting down and > then removing the power does solve the problem. <snip> > Some additional information that may be useful. The TrendNet card is > the second TrendNet card I have used. The first card had the same > symptoms, and I deduced the card was bad, and purchased another one. The > symptoms are the same with the second card. <snip> Several questions: do you have another machine on the same network? Does *it* show the problem, around the same time?
And, finally, did you buy both TrendNet cards from the same vendor? Are their MACs close? If so, it could be the vendor got a bad batch, either OEM's fault, or the gorilla who un/loaded it during shipping.
mark
Mark,
I have several machines on that network, and only one machine is having the problem. The machine is being used as a mail server, web server, and gateway for the network. After this problem surfaced with the failure of the eth4 card (internal network), I created a gateway out of one of the other machines that is working without incident.
I did purchase both TrendNet Cards from Fry's. Fry's was good about taking the first one back without question, but now that the second one has failed, I thought it best to look deeper. I don't have the previous card's MAC address, but my first thought was that this was a bad card too. Both the first and second cards did not appear to have any damage on the boxes or the card itself. Before I tried to get a third card from a different manufacturer I wanted to post things here to see if there was an obvious problem I am missing.
Thanks for your help!!!
Greg
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
If you are having to fully 'cold boot' the system before it will work again I can't help but wonder if it is a conflict between special motherboard functions/settings and the card. I've seen this with some high end video cards under Winders. I am totally speculating here and have nothing to draw from, but wake on lan functions and such.... just leaves me wondering. Do you have a different machine/motherboard around where it wouldn't be hard to set up this testing? Maybe Googling a bit on motherboard model and eth card model might give a helpful return?