Nicolas Thierry-Mieg wrote:
Robert Moskowitz wrote:
That covers speed, but doesn't say anything about the duplex setting. You should see this mentioned near the Ethernet driver load lines in dmesg, too.
Do you see anything in the lines I pasted above? Those are the only ones from dmesg.
try: ethtool eth0
thanks:
ethtool eth1 Settings for eth1: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 32 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: d Current message level: 0x00000007 (7) Link detected: yes