--- Craig White craigwhite@azapple.com wrote:
I have an issue with cdrecord though and I can't figure it out. I use Webmin, which basically just creates an iso and then uses cdrecord to burn it and it worked fine with previously installed CentOS 4 (I wiped and reinstalled about 8 months ago).
This is the command that Webmin tries to execute...
cdrecord -v dev=0,0,0 speed=4 -isosize \ '/home/Linux/CentOS-4/CentOS-4.2-i386-bin4of4.iso'
The result of cdrecord -scanbus at bottom of email. Log of error just below.
Help appreciated...
Craig
cdrecord: No write mode specified. cdrecord: Asuming -tao mode. cdrecord: Future versions of cdrecord may have different drive dependent defaults. cdrecord: Continuing in 5 seconds... scsidev: '0,0,0' scsibus: 0 target: 0 lun: 0 cdrecord: No such file or directory. Cannot open '/dev/pg0'. Cannot open SCSI driver. cdrecord: For possible targets try 'cdrecord -scanbus'. cdrecord: For possible transport specifiers try 'cdrecord dev=help'. Cdrecord-Clone 2.01-dvd (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling Note: This version is an unofficial (modified) version with DVD support Note: and therefore may have bugs that are not present in the original. Note: Please send bug reports or support requests to http://bugzilla.redhat.com/bugzilla Note: The author of cdrecord should not be bothered with problems in this version. TOC Type: 1 = CD-ROM
# cdrecord -scanbus Cdrecord-Clone 2.01-dvd (i686-pc-linux-gnu) Copyright (C) 1995-2004 J�rg Schilling Note: This version is an unofficial (modified) version with DVD support Note: and therefore may have bugs that are not present in the original. Note: Please send bug reports or support requests to http://bugzilla.redhat.com/bugzilla Note: The author of cdrecord should not be bothered with problems in this version. scsidev: 'ATA' devname: 'ATA' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Using libscg version 'schily-0.8'. cdrecord: Warning: using inofficial libscg transport code version (schily - Red Hat-scsi-linux-sg.c-1.83-RH '@(#)scsi-linux-sg.c 1.83 04/05/20 Copyright 1997 J. Schilling'). scsibus0: 0,0,0 0) 'COMBI ' 'RW16x10/DVD ' 'H1.1' Removable CD-ROM 0,1,0 1) * 0,2,0 2) * 0,3,0 3) * 0,4,0 4) * 0,5,0 5) * 0,6,0 6) * 0,7,0 7) *
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
craig,
the only time i have had troubles like that is when the ide-cd would load before the ide-scsi. check to see if both ide-scsi and ide-cd are loaded....but not sure if this is your problem.. can not remember if i was able to see the drive when this happened to me.
Steven
"On the side of the software box, in the 'System Requirements' section, it said 'Requires Windows or better'. So I installed Linux."