Alexander Georgiev wrote:
Hi people,
I installed a via SATA controller in a CentOS release 3.8 (Final) - I needed additional disk space. After the first boot, the kudzu service, added the following line to /etc/modules.conf:
alias scsi_hostadapter sata_via
and I rebooted. After reboot in dmesg one can see:
scsi0 : sata_via scsi1 : sata_via Vendor: ATA Model: SAMSUNG HD080HJ Rev: WT10 Type: Direct-Access ANSI SCSI revision: 05 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB) sda: sda1 sda2 < sda5 > sda3 scsi : 0 hosts left
But the /dev/sda device is not present in the system. If I issue the command:
[root@bdc root]# fdisk /dev/sda
Unable to open /dev/sda
I found out that if at that point I issue the command:
[root@bdc root]# modprobe scsi_hostadapter
the /dev/sda is inserted in the system and I can access it using fdisk. It appears to me that scsi_hostadapter is initially loaded during boot, later unloaded - therefore the drive is missing.
Currently I patch the situation with a file /etc/rc.modules with the following contents:
#! /bin/sh
modprobe scsi_hostadapter
However I assume that this is not the correct way to fix this. Maybe I need additional lines in modules.conf?
Best regards, alex
Alex,
Possibly rebuilding your inird will correct this. I'm not sure if kudzu does this or not, but mkinitrd will add the correct scsi_hostadapter to the modules that gets loaded as part of the initial RAMDISK (see the man mkinitrd).
Bob...