Alon wrote:
Hi All,
I have several dozens of CentOS and WhiteBox servers. Most of them are CentOS 4.6. Our installation service is done in the datacenter where the servers are located.
When we install a fresh clean install, we use the GUI menus, while using the KVMoverIP.
That was working great with CentOS 4.x
In CentOS 5.x, the installation process 'annonces" that "Hey,. I know you are using a KVM and don't have a monitor attached" (who cares??). But, "since you are using a KVM and no monitor is attached,. you CANNOT use the GUI installation".
Why???
4.x didn't care for this.
Why make my life difficult?
I have to 'cheat' by calling the datacenter to plug a monitor for the first minute of the install and then plug back the KVM cable. Isn't this stupid? of course it is!
I am looking for a solution such as a parameter that I can pass to the boot sequence (vga=nommconf or something like that) so that it won't do the probing for the VGA and just let me go about my business.
Mind you that this is a problem both with DELL PowerEdge 1950iii with DRAC5 remote consule as well as with just plain PCs that use ATEN KVM 9116. Once the probe understand that we don't use a monitor it prompts the 'can't use the GUI'.
Any pointers about this?
No really pointers to give you, but with so much machines to install/manage, why not using kickstart for your installations ? Faster than manual installations ... (for virtual or real nodes) And if you really want to use anaconda in gui mode, why not just launch the install with vnc and take the gui remotely ? On the other hand, i know that anaconda gui in 5.X is working ok with remote kvm (i've tested on IBM RSA2 and IBM BladeCenter MM and Advanced MM)
- Fabian Arrotin fabian.arrotin@arrfab.net "Internet network currently down, TCP/IP packets delivered now by UPS/Fedex ..."