Hi there, after installing C7, on fist boot I get this messages:
failure reading sector 0xfc from 'hd2' failure reading sector 0xe0 from 'hd2' failure reading sector 0x0 from 'hd2'
Press any key to continue
Entering in grub menu, and typing ls, I get info for hd0 hd1 but not hd2. hd2 in my case is dvd-rom. Once disconnected there are no errors.
How I can solve this problem with cd-rom?
THanks in advance
Il 13/03/2016 09:23, Alessandro Baggi ha scritto:
Hi messmer, seems that anaconda supports partitioned RAID devices. Disk selection see one mdraid device and permits to create partition on it.
Il 13/03/2016 01:04, Gordon Messmer ha scritto:
On 03/12/2016 08:22 AM, Alessandro Baggi wrote:
From several how-to concerning raid1 installation, I must put each partition on a different md devices.
Not necessarily. You could put LVM on top of the RAID device, and create logical volumes.
I've asked times ago if it's more correct create the md device, partitioning it and create fs on each partition created on md device:
Partitionable RAID devices are supported by Linux, but not by the Anaconda installer. You're better off not using them.
I'm installing C7 1511 on a skylake machine with UEFI and I'm confused. After googling, for my installation I must create gpt table, 1 partition with fat32 type of 512M, and 2 partition for swap and / (I've excluded /home), clone gpt partition table on second disk with sgdisk, create md device for swap and /.
Don't clone the partitions. If you do that, then you also need to randomize the UUIDs on the destination drive. It's probably easier to just create the partitions on each disk:
parted -s /dev/sda mklabel gpt \ mkpart primary ext4 1M 200M \ mkpart primary ext4 200M 1224M \ mkpart primary ext4 1224M 100% parted -s /dev/sdb mklabel gpt \ mkpart primary ext4 1M 200M \ mkpart primary ext4 200M 1224M \ mkpart primary ext4 1224M 100%
CentOS mailing list CentOS@centos.org https://lists.centos.org/mailman/listinfo/centos