On 12/27/2010 02:37 PM, E Westphal wrote:
On Mon, 2010-12-27 at 17:29 -0500, Ryan Wagoner wrote:
On Mon, Dec 27, 2010 at 5:22 PM, E Westphal <enwestph@rochester.rr.com mailto:enwestph@rochester.rr.com> wrote:
Have you experienced this? What's going on when this occurs? What do I need to do to keep it from occurring? Please advise. Thanks.
Dec 4 10:18:28 localhost kernel: e1000: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX Dec 4 10:18:29 localhost kernel: e1000: eth1 NIC Link is Down
What is the NIC connected to? Have you tried a different switch port or network cable? Does rebooting the server make the problem go away for a bit? It seems like you need to perform some basic troubleshooting and let us know what you have an have no tried.
Ryan _______________________________________________
I've tried all the obvious things. Cables, router ports, rebooting etc. It's quite strange. From a cold bootup, it's fine. Then about 45 minutes later it starts to act up. None of the obvious things seem to help. Then, about 90 minutes after bootup, everything is fine again! Rock solid! Ethtool and anything else I've tried fails to yield any hints, thus my question to all of you.
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
Are running the latest CentOS 5.5 release with all updates installed? Back around 5.0 through at least 5.1, possibly even 5.2, there were some driver bugs that affected some ethernet cards. I have also seen problems that showed up with cheap switch hardware and went away when plugged into a different switch. As far as inexpensive switches go, the low end HP managed switches are one of the few that I've had good luck with.
Nataraj