Hi,
On Mon, 2008-06-30 at 10:33 -0400, Robert Moskowitz wrote:
I had been running a system on Centos 5.1 at INIT 3. I did the upgrade to Centos 5.2 with the aid of the powernowk8 patch.
Previously I would VNC into the unit when I needed to do admin stuff with a GUI. Well I noticed that I was NOT getting GNOME via VNC since the upgrade (worked before just fine with 5.1). So I tried an INIT 5 from the command line (always worked before), but the system seemed to hang. Video was off.
I rebooted, went to INITTAB and changed init to 5 and rebooted. Probably a tragic mistake.
Now on boot, right after UDEV gets an OK, the screen goes blank and the drive stops turning.
I tried booting with the 5.1 kernel, and same behaviour with the system blanking out and all load activity stopping after UDEV loads.
So I am quite stuck at this point.
Is there an option that I can edit into the kernel command at boot time to init in 3? And then what do I try?
Reboot your system, when you see the grub menu, press a key. Select the kernel you wish to boot and press 'e', select the kernel line, press 'e' again and add '3' at the end of the line (or '1' if you wish to boot in single user mode). Then press <enter> and 'b' to boot. Your system should now boot up in level 3. You can log in as root at the login prompt. If that even doesn't work, the reboot in single user mode.
For the rest, we first need logfiles, /var/log/messages /var/log/boot.log and maybe /var/log/Xorg.0.log
Regards,
Michel