Jerry Geis wrote:
I used the following command to solvee the missing kernel problem.
./configure --with-port=0x3f8 --with-irq=4 --with-transmitter --enable-sandboxed --with-driver=serial --with-kerneldir=/lib/modules/2.6.9-11.EL/build
Things are going much better now..
Jerry
Karanbir,
I am still having problems. I grabbed the rpm and installed it. I could not get a /dev/lircd device. I put the lirc.rules in /etc/udev/... even rebooted and still not there.
I then grabbed the src rpm, went through the normal stuff and tried to run ./configure and it tells me I need the kernel source installed. I have the kernel source installed.
I am just selecting the default of serial when I run ./configure.
I would like to do this from the source package - but the kernel source keeps stopping that...
Any further ideas? Jerry
Jerry Geis wrote:
// I am trying to compile lirc.0.7.1 from www.lirc.org and it is indiacting
//>/ that />/ kernel source is not installed. />/ />/ I then installed kernel source and ran the ./configure again. Same message />/ about kernel not being installed. />/ />/ ANyone compiled lirc.0.7.1 on centos 4.1? / You can get a pre-built lirc-0.7.1 for i386 at : http://centos.karan.org/el4/extras/stable/i386/RPMS/repodata/repoview/L.grou...
the source for it is http://centos.karan.org/el4/extras/stable/i386/SRPMS/lirc-0.7.1-1.src.rpm
You might want to take a look at how its packaged, make changes etc in the .spec and rebuild for your own needs.
I'll take a look at the issue later in the day, when I am near a build machine... but take a look at the '--with kmod' option in the .spec - By default the kernel modules are not built.
w.r.t the kernel source - you need to get the kernel-*.src.rpm from mirror.centos.org/centos/4/SRPMS/ and install that, also check to make sure that configure script is looking at the right place for it.
- KB
PS: Do we need to start a new thread with every reply ?