Have you inspected via the system iLO console? Assuming it's cabled to the network
On 08/21/2014 01:33 PM, GKH wrote:
Hate to change the conversation here but that's why I hate hardware RAID. If it was software RAID, Linux would always tell you what's going on. Besides, Linux knows much more about what is going on on the disk and what is about to happen (like a megabyte DMA transfer).
BTW, check if something is creating:
/forcefsck
That would make the fsck run every time.
GKH
Matt wrote:
I have CentOS 6.x installed on a "HP ProLiant DL380 G5" server. It has eight 750GB drives in a hardware RAID6 array. Its acting as a host for a number of OpenVZ containers.
Seems like every time I reboot this server which is not very often it sits for hours running a disk check or something on boot. The server is located 200+ miles away so its not very convenient to look at. Is there anyway to tell if it plans to run this or tell it not too?
Right now its reporting one of the drives in array is bad and last time it did this a reboot resolved it.
You need to know what it's running. If it's doing an fsck, that will take a lot of time. If it's firmware in the RAID controller, that's different. You can run tune2fs /dev/whatever and see how often it wants to run fsck. For that matter, what's the entry in /etc/fstab?
mark
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos