When I do an install, it gets to where it is trying to load the installer (cannot remember the exact verbage) where it pauses for about 30 seconds.  Then I get the panic and it has something to do with Interrupts.

This is done with the RAID disabled and the disk pair plugged into into the non-RAID ATA socket.

All works fine with RH 9.   Does it have anything to do with Celeron 2.2 on the board?  Someone told me that it may be due to the fact that some Intel chips are threaded.

I had no problem with an old Pentium III board.

Your assistance is greatly appreciated; especially since I seldom need to "look under the hood".

Paul wrote: 
On Sun, 2005-09-11 at 14:31 -0700, Todd Cary wrote:
  
Unfortunately RH only indicates assembled servers rather than
motherboards.  Mine is assmbled by me and I would like to replace the
motherboard with one that is compatible.
    

What issue where you having?

I looked at the the specs Intel 845PE and Highpoint HPT372 all should be
compatible with CentOS 4.1.  The RAID won't work on the HPT372 since
it's a "Fake RAID" controller (had one on a KT7-RAID that I used just as
IDE channels), but it should be recognized as just an extra IDE adapter.

Paul

_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos


  

-- 
Ariste Software
200 D Street Ext
Petaluma, CA 94952
(707) 773-4523