On 10/25/2016 05:41 AM, Sorin Srbu wrote:
I found a shortcut for creating a software RAID 10 ("--level=10"), device in CentOS 6.
That's not really a shortcut, per se. RAID10 in Linux is not necessarily similar to RAID1+0. The default, "near" layout is the classic 1+0 layout, but other modes of operation are supported by the RAID10 driver.
Looking at the below, I don't see anything about a shortcut for RAID 60.
Correct. There's no such driver.
Besides, I haven't found any way to fail a member disk, as is possible to do when using RAID level 10.
If you built a RAID0 array of RAID6 arrays, then you'd fail a disk by marking it failed and removing it from whichever RAID6 array it was a member of, in the same fashion as you'd remove it from any other array type.