On 08/30/2011 03:23 PM, Ned Slider wrote:
On 30/08/11 20:08, Michael D. Berger wrote:
In setting up my new CentOS 6 laptop, I replaced /etc/sysconfig/iptables with my own, very restrictive version. I then tried to restart the iptables daemon, but it reported that my new iptables was unreadable. On a guess, I disabled selinux, and my problem was solved. Later, I re-enabled selinux and on reboot, it had to go through a very long setup procedure.
Rather than disabling, you can put SELinux in permissive mode to troubleshoot. Permissive mode will warn but still allow all actions that would otherwise be blocked in enforcing mode.
Further to this, chcon --reference <originalfile> <newfile>, then test with selinux back in enforcing mode.
When you disable SELinux and then later re-enable it, the whole file system will need to be relabeled at boot, and this is probably what took the time on your system. Switching between permissive and enforcing modes avoids this.
Regards,
Phil