Hi,
On Wed, Mar 9, 2011 at 6:57 PM, Les Mikesell lesmikesell@gmail.com wrote:
Some controllers want to map arrays to volumes and present the volumes to the OS instead of drives, so you have to go through the motions of assigning the resources to volumes and initializing them even if you only want one disk in the array or volume.
I am pretty sure this was done already as that was what I had been told, and I remember seeing on the screen during the bootup messages about the drives being initialized and RAID5 working ok. But its been a while since I've been working with hardware issues so I will double check this tomorrow and show you the config.
So is it so that the LSI 1068E Controller *should* be supported by megaraid_sas driver and the net install should use it without any driver disk needed?
Regards, Peter