On Sat, Aug 9, 2008 at 1:29 PM, Jancio Wodnik jancio_wodnik@wp.pl wrote:
Akemi Yagi pisze:
On Sat, Aug 9, 2008 at 12:29 PM, Jancio Wodnik jancio_wodnik@wp.pl wrote:
As i remember: hdlc is build not as module, it is core kernel module, not module to load by modprobe - so in menuconfig is [*] with hdlc not [M] as module.
But maybe i'm wrong.
Just to expand this a bit...
Go to Device Drivers -> Networking support -> Wan interfaces -> Wan interface support (y or n only).
In the 'Wan interface support' menu, check 'Generic HDLC layer' (y, n, or M).
Inside the 'Generic HDLC layer', there are a few support options (y or n)
The above layout is for CentOS-5, but CentOS-5 is similar. Hope this helps,
Err... I meant "above layout is for CentOS-4"
Akemi
you are right, only raw hdlc support and raw hdlc ethernet support are as [*]. My fault.
I don't see any "fault" ... :-)
Akemi
Irek