Hey List,
So I had a 4 drive software RAID 5 set up consisting of /dev/sdb1, /dev/sdc1, /dev/sdd1 and /dev/sde1. I reinstalled my OS and after the reinstall I made the mistake of re-assembling the array incorrectly by typing "sudo mdadm --assemble /dev/md0 /dev/sdb /dev/sdc /dev/sdd /dev/sde" in a moment of stupidity.
Obviously this didn't work and the array wouldn't mount and after a short period I realised my mistake and re-issuing the same command but specifying each drive partition (sdb1, sdc1 etc) instead of the drives (sdb, sdc etc) meant the raid would assembled and mount just dandy. My problem is that when I issue "sudo mdadm -E --scan" I get the following results:
ARRAY /dev/md0 level=raid5 num-devices=4 UUID=fde94900:3f3f3bf6:e368bf24:bd0fce41 ARRAY /dev/md0 level=raid5 num-devices=4 UUID=3a2f1919:52f73b40:e368bf24:bd0fce41
These entries aren't in mdadm.conf but mdadm keeps picking up my first mistake and tries to make a raid out of my four drives and not the four partitions (the bottom line is the four UUIDs for the partitions on each drive, the top line is the four UUID for the drives). So now every time I restart the machine, the array isn't mounted because mdadm (I guess) doesn't know what to do as it has two sets of devices defined as /dev/md0. I can issues "sudo mdadm --stop /dev/md0" and "sudo mdadm --remove /dev/md0" and then re-assemble specifying the four partitions and carry on as normal but I can't work out how to tell mdadm to "forget" about the the top line of those results, if that makes any sence? I have removed the entries from fstab and from mdadm.conf so when I boot up the machine doesn't automatically try and mount the incorrect device but I still can't remove the top line from the results of "mdadm -E --scan" no matter what I do.
I have rebooted and issued the command "sudo mdadm --assemble /dev/md1 /dev/sdb1 /dev/sdc1 /dev/sdd1 /dev/sde1" and I can mount my array as normal but I was hoping that now there wouldn't be a clash in the results of "sudo mdadm -E --scan" (which there isn't, the second lines says "/dev/md1"), meaning that after a reboot the array would mount properly but that isn't the case. It is still trying to assemble the top line.
Does anyone have any idea how I can rectify this?
Thanks for reading.