Dear All,
Thanks for all the help.
By the way I did install centos 5.5 in text mode and everything went fine .cthe server to the network and then found that i was not able to ping the gateway
when i do a network restart i see that eth0 comes up normally
also when i do a modprobe eth0 im returened back to prompt with no errors
the switch port shows the link up
ifconfig shows the interface is up and running
how could I know that the driver is installed correctly .. or any way i could know that my interface is up and working correctly
thanks and regards
if you need more details i would highly apprecite if you could ask please
regards
simon
On Dec 14, 2010 5:18pm, Ross Walker rswwalker@gmail.com wrote:
On Dec 13, 2010, at 11:49 PM, Nico Kadel-Garcia nkadel@gmail.com> wrote:
On Mon, Dec 13, 2010 at 10:01 AM, benedict dcunha
sylvan.dcunha@gmail.com> wrote:
Dear All,
We have a new SUN BLADE X6270 SERVER MODULES and i am trying to install
centos 5.5 64 bit . the installations starts fine but when it reaches
the
point inialthe X server it says initialization done but then gives a
fatal
error and stops
Install in text mode: type "linux text" at the installation init
screen. It's not as flexible, but it avoids this failed detection of
your graphics chipset or video card.
Or use the 'vnc' option to make it available over vnc instead then connect from any vnc capable device to do the installation.
-Ross
CentOS mailing list
CentOS@centos.org