In article 4EF0939C.9030907@emmanuelcomputerconsulting.com, William Warren hescominsoon@emmanuelcomputerconsulting.com wrote:
On 12/20/2011 12:59 AM, Barry Brimer wrote:
- The switch being used has autoneg off and has port set to 100 full duplex.
- Many times NIC fails to come up properly during PXE boot:
Any other ideas?
udev rules? mii-tool?
re-enable autoneg on switch?
Indeed. I once worked at a large ISP where the network admins thought they were increasing "reliability" by setting all the switch ports to fixed 100Mb-FD without auto-negotiation. All it achieved was that any new machines where someone had not remembered to set the fixed config for the network port would attempt to auto-neg, fail to do so, and fall back to Half Duplex. That resulted in many collisions and very poor throughput.
If only they had left all the ports on autoneg and then only set a fixed mode on specific ports for machines that would not negotiate properly, which would have been a very small minority! But it's hard to convince someone whose job function implies that they are the expert...
Sorry for the rant - just pushed a button, that's all!
Cheers Tony