Billy Huddleston wrote:
It's listed as a MegaRAID controller. I've tried the following drivers suggested by Supermicro with no success.
megasr-13.10.0708.2009-1-rhel50-ga-all.img megasr-13.10.0708.2009-1-rhel50-u1-all.img megasr-13.10.0708.2009-1-rhel50-u2-all.img megasr-13.10.0708.2009-1-rhel50-u3-all.img
From what I can tell from reading, it is a software RAID and putting
it in IT mode makes it work as a JBOD. I'm not understanding how to do RAID 10 with it in IT mode.
If it is JBOD then correct me if I'm wrong but it is "just a bunch of disks" and needs software raid
Thanks, Billy
Larry Brigman wrote:
On Fri, Nov 27, 2009 at 2:35 PM, Billy Huddleston billy@ivdc.com wrote:
I'm trying to install CentOS 5.4 on a machine with a LSI SAS 1068E controller. I've googled all over the place and found a few different drivers for RHEL5 for it.. and tried a few of them.. Some will load, some complain that this isn't the correct version.. non of them work when it comes to showing Hard Drivers in the partition manager. The machine is a Supermicro SYS-6015V-M3 server. Any help would be appreciated.
run lspci on the system from the rescue mode of the installer disk. It will probably say something like Megaraid.
We have a newer motherbaord from Super Micro and we had the same problem. The motherboard data info says LSI 1068E but depending on the jumper setting of the board it could be 1078E instead and that is not supported by Linux until a much later kernel (2.6.32).
Jumper for IT mode and get the IT firmware and things will work correctly. _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos