Many thanks and it works fine.
Cheers, Xiaobo

On Thu, Jan 8, 2009 at 10:04 AM, Ray Van Dolson <rayvd@bludgeon.org> wrote:
On Thu, Jan 08, 2009 at 09:57:51AM +0800, Xiaobo Zhu wrote:
> Hi,
> When I connect to a Cisco router and issue the show ip interface command, the
> output is similar as follows:
>
> Interface                  IP-Address      OK? Method Status
> Protocol
> Ethernet0/0               192.168.12.1      YES NVRAM  up
> up
> Serial0/0                  unassigned      YES NVRAM  administratively down
> down
> Ethernet0/1               unassigned      YES NVRAM  administratively down
> down
> Loopback0               1.1.1.1            YES NVRAM  up
> up
>
> Will anyone please tell me how to select text in block instead of line,  so
> that I can get the IP address on all interface, in gnome-terminal as well as in
> vim.
> Many thanks!
>
> Xiaobo

You should be able to do this in visual mode in VIM.  Paste your output
above into vim and then hit CTRL-C CTRL-V and select away.

Ray
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos