Am 12.05.2012 18:59, schrieb Gregory P. Ennis:
On 5/12/2012 11:39 AM, Gregory P. Ennis wrote:
OK, I do have lspci on this system; I am going to it down and put the st1000spex back in the slot, and will send the lspci out put after I reboot.
Greg
is the eth cable plugged in all the way? _______________________________________________
Bob,
At this point i would sure take the fix if that were the problem. I have the lights active on the mother board nic and the nic on the st1000spex.
Here are the facts of the scenario that I have with the st1000spex inserted in the pci-e slot :
lspci : 01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 03) 02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 06)
The first entry references the mother board nic and the second references the st1000spex. Since both of these cards seem to have the same chipset i would think this would be an easy thing to set up.
ifconfig only displays eth0, and does not display eth1
When I execute the command :
service network restart
eth0 is removed and restarted
then I get :
Bringing up interface eth1: Device eth1 does not seem to be present. delaying initialization.
Are both devices specified within /etc/udev/rules.d/70-persistent-net.rules?
I have NetworkManager turned to off
I have /etc/sysconfig/networking/ #PCI-E Slot #1 #StarTech 10/100/1000 #HWADDR=00:0A:CD:1E:4D:F6 DEVICE=eth1 NAME="Internal Facing Network eth1" ONBOOT=yes NM_CONTROLLED=no TYPE=Ethernet BOOTPROTO=none IPV4_FAILURE_FATAL=yes IPV6INIT=no DEFROUTE=yes IPADDR=10.0.0.134 NETMASK=255.255.255.0 DNS1=127.0.0.1 DOMAIN="pomec.net" UUID=4f637674-df3f-4fa8-a81a-8259563a1b1f PREFIX=24 USERCTL=no
I have /etc/sysconfig/network-scripts/icfg-eth1
set to :
#PCI-E Slot #1 #StarTech 10/100/1000 #HWADDR=00:0A:CD:1E:4D:F6 DEVICE=eth1 NAME="Internal Facing Network eth1" ONBOOT=yes NM_CONTROLLED=no TYPE=Ethernet BOOTPROTO=none IPV4_FAILURE_FATAL=yes IPV6INIT=no DEFROUTE=yes IPADDR=10.0.0.134 NETMASK=255.255.255.0 DNS1=127.0.0.1 DOMAIN="pomec.net" UUID=4f637674-df3f-4fa8-a81a-8259563a1b1f PREFIX=24 USERCTL=no
Alexander