Andrew Allen wrote:
On Tue, 2009-09-01 at 20:06 +0100, Ned Slider wrote:
Andrew Allen wrote:
I've just installed CentOS 5.3 on my Dell laptop and it seems to have detected and set-up my wireless card (BCM 4311) correctly as eth1. However, so far I haven't been able to activate it and have read the wiki http://wiki.centos.org/HowTos/Laptops/Wireless#head-320d6fcf09b7e16e0b15d19e... which indicates that this card isn't actually supported in CentOS - but there has been an improvement over earlier kernels because the card wasn't even detected in CentOS 5.0. So do I need to get the Windows driver from http://www.broadcom.com/support/802.11/linux_sta.php and do I need ndiswrapper as well?
Andy
That's not a Windows driver, it's a native Linux driver that you sould download and compile for your kernel. Being a native Linux driver, it doesn't require ndiswrapper. The ndiswrapper section is the next section on that Wiki page and is unrelated (is it confusing?).
I believe this topic was also discussed recently on this mailing list (a few months back iirc).
Thanks, You don't happen to know when that was do you? It would be great to benefit from somebody else's experience, if they've managed to get this card working in CentOS (5.3). Trouble is, the instructions in the readme.txt on the Broadcom website obviously aren't CentOS specific. In the past I've installed additional stuff (eg skype) from repos using yum, which works brilliantly - I'm a bit wary of trying to install by other means!
Andy
Here you go:
http://lists.centos.org/pipermail/centos/2009-July/079638.html