I want to configure IPV6 on the system and not use some auto ipv6 config. I have tried to use IPV6_AUTOCONF=no in interface script dose not affect anything.
ifcfg-eth0: GATEWAY=192.168.1.254 IPV6INIT=no IPV6_AUTOCONF=no BROADCAST=192.168.1.255 BOOTPROTO=none NAME="" NM_CONTROLLED=yes MACADDR="" TYPE=Ethernet DEVICE=eth0 NETMASK=255.255.255.0 MTU="1500" IPADDR=192.168.11.1 NETWORK=192.168.11.0 ONBOOT=yes
The above file should have resulted an interface with only inet address but the result is: eth0 Link encap:Ethernet HWaddr XX inet addr:192.168.11.1 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::7271:bcff:febd:c46b/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:24452216 errors:0 dropped:0 overruns:0 frame:0 TX packets:38068314 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:6777513704 (6.3 GiB) TX bytes:21817051849 (20.3 GiB) Interrupt:29 Base address:0xc000
Thanks, Eliezer Croitoru