Frank,
but as noticeable from my routing table, I have several VLANs iniside my local network - for servers, computers, wifi's, and voip.
Each VLAN has it's own DHCP which assigns ip address with netmask 255.255.255.0 and uses particular VLAN interface on router as a gateway. If I will do so. I will lost a route between my VLAN's that way and I do not want to use netmask 255.255.0.0 so computers in local lan can communicate without router.
Thank you in advance,
David Hlacik
On Sun, Dec 20, 2009 at 11:04 PM, Frank Cox theatre@sasktel.net wrote:
On Sun, 2009-12-20 at 19:54 +0100, David Hláčik wrote:
Computers from local network range 10.123.123.0/24 (eth0.7) should access internet using my second internet provider via ppp0.
This may be too simple for your needs, but it took a while for the light to come on for me about this when I set up something similar.
I have two Internet connections, one cable and one DSL. I want to have some of my computers on the cable connection and some on the DSL connection, but I want all of my computers to be on the same internal network.
Solution: Put a router on each modem with a different address. Assign the default gateway on each computer depending on what outside connection it is supposed to use. 192.168.0.1 == cable, 192.168.0.254 == DSL.
Nothing to it.
-- MELVILLE THEATRE ~ Melville Sask ~ http://www.melvilletheatre.com
CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos