On Fri, 2009-07-03 at 17:58 -0400, Thomas Dukes wrote:
-----Original Message----- From: centos-bounces@centos.org [mailto:centos-bounces@centos.org] On Behalf Of Thomas Dukes Sent: Friday, July 03, 2009 5:55 PM To: 'CentOS mailing list' Subject: Re: [CentOS] ffmpeg and zoneminder install problems
-----Original Message----- From: centos-bounces@centos.org [mailto:centos-bounces@centos.org] On Behalf Of Gregory P. Ennis Sent: Friday, July 03, 2009 2:24 PM To: CentOS mailing list Subject: [CentOS] ffmpeg and zoneminder install problems
CentOs zoneminder users,
I have been trying to install zoneminder on Centos 5.3 (2.6.18-128.1.16.el5xen) and have hit a brick wall with
ffmpeg which
zoneminder has as a dependancy.
There were no rpm's in centos or rpmforge so I have followed the instructions on the zoneminder website for a CentOs install.
I have posted a note on the zoneminder list, but have not
been able to
get any takers to assist me. I am not a C programer so I
have a lack
of understanding as to how to proceed.
I have followed the steps outlined on zoneminder site as to how to install on Centos 5.3
http://www.zoneminder.com/wiki/index.php/CentOS
The sequence step I have not been able to pass beyond with these instructions is the following :
svn checkout -r 11879 svn://svn.mplayerhq.hu/ffmpeg/trunk ffmpeg cd ffmpeg/ ./configure make
When I execute the make command I get the following that
results in an
Error message.
I noticed that some of you have been able to use zoneminder
on Centos
5.3, Can you help me get zoneminder installed.
Thank you much,
Greg Ennis P.S. here is the output of make
Sorry,
I see you are following the guide. What version of zoneminder are you trying to install? 1.23.3 will work with ffmpeg 11879, but I had to use a more current version to get 1.24.1 to complie. I'm using version 17697. Its just what was available the day I re-installed 1.23.3 after I have problems with 1.24.1.
Do a search for my posts "tdukes" on the forum. I posted some steps I used so I could go back to them if needed.
Eddie
PS,
I used the following configure parameters: --enable-shared --enable-swscale --enable-gpl --enable-pthreads
Eddie,
Hey ... Thanks for the heads up. I will back out the rpm instal of ffmpeg, and check out your notes. Wish I could launch into it now, but my wife has an outing planned so I will have to wait until tonight or tomorrow to pursue your thread.
Again, thank you very much!!!!
Greg