Jay Hilliard wrote:
In your pxelinux config file:
add ksdevice=bootif
also add "IPAPPEND 2" to the end of the file
In your kickstart file, don't specify a device: "network --bootproto dhcp"
-Jay
Karl R. Balsmeier wrote:
yeah, it can be a bit daunting at first, but the below info is right. also consider down the road if you are using PXE/DHCP that there can be conflicts, so PXE to eth0, kickstart to eth1, that sort of thing. -krb
nate wrote:
Keith Christian wrote:
PXE begins the install with DHCP, so Kickstart should already know which of eth0, eth1, etc. to use.
add ksdevice=eth0 to your kernel parameters, or eth1 if you want to use eth1. This works for me anyways.
nate
--device=
Used to select a specific Ethernet device for installation.
Note that using --device= will not be effective unless the kickstart file is a local file (such as ks=floppy), since the installation program will configure the network to find the kickstart file. For example:
network --bootproto=dhcp --device=eth0
Extracted from one of the pages I sent earlier.
-Ross-