-----Original Message----- From: centos-bounces@centos.org [mailto:centos-bounces@centos.org] On Behalf Of Scott Silva Sent: Thursday, October 05, 2006 11:57 PM To: centos@centos.org Subject: [CentOS] Re: Cannot re-make a software raid pair
Nigel Kendrick spake the following on 10/5/2006 3:48 PM:
-----Original Message----- From: centos-bounces@centos.org [mailto:centos-bounces@centos.org] On Behalf Of Scott Silva Sent: Thursday, October 05, 2006 11:15 PM To: centos@centos.org Subject: [CentOS] Re: Cannot re-make a software raid pair
Nigel Kendrick spake the following on 10/5/2006 12:45 PM:
Apologies if you get this twice - the first one didn't seem to make it...
Hi Guys,
I have just replaced a faulty Max...woah, wait...this one's a Seagate... IDE hard disk but I cannot remake the software raid pair.
[SNIP]
I know this is a real basic question, but did you fail then remove the old drive first?
Hi Scott,
Yes I did, but half the problem is/may be that the faulty drive is not even 'seen' by the server and so software RAID takes it out of the mirrored pairing on boot and I am pretty sure that when I 'failed' it it threw an error that the drive wasn't there anyway. I will try again and also see if I can get the drive recognised so I can 'fail' it.
Thanks again for the feedback
Nigel