-----Original Message----- From: centos-bounces@centos.org [mailto:centos-bounces@centos.org] On Behalf Of Mark Hull-Richter Sent: Thursday, August 02, 2007 6:02 PM To: CentOS mailing list Subject: Re: [CentOS] Re: Can't print PDFs or PSs in CentOS 5.0
On 8/2/07, Ross S. W. Walker rwalker@medallion.com wrote:
Ok, so it's not a general postscript failure, but maybe just EPS...
EPS?
As the other poster pointed out it encapsulated postscript, a lot of bitmaps are bound in an encapsulating postscript object wrapped in a postscript object for printing.
If the printer needs a hard-reset to recover then it is probably because the printer isn't fully PCL compatible as it advertises, can you try using an HP Deskjet engine which does PCL 3?
It usually takes two or three power cycles to get the printer to quit being stupid about it (so to speak). I also have to cancel the print job (of course).
If you kill the job first then power cycle the printer it could be done in 1 I bet, otherwise the job keeps pumping output to the printer and you get a ton of garbage.
I'm not sure how to do what you suggest here. In AR on the 'print' window, there are a few options I've tried differently. The default is optimize for speed and use level 2 (I'm guessing that's PCL level 2). I've tried setting it to 'save printer memory' and 'use level 3', neither of which works.
Not in reader, but down at the CUPS setup when you setup your printer originally you probably chose a model from the foomatic database that was close-enough, go back and change that model to HP Deskjet which should provide the lowest level of PCL support that almost all PCL compatible printers should support. If that works then try an HP LaserJet 4 next, if that works then you have a good fall-back.
The levels in AR correspond to PostScript levels and not PCL, I think it's a PCL compatibility issue that your hitting here.
You can also scan the Internet to see if someone has put together a working CUPS PPD (different PPD than the standard postscript printer definition) file for your particular model.
What usually happens is that the green light on the printer flashes for a few seconds, indicating that it is processing the file, then the red light goes on steady (I don't know how to retrieve the printer status on Linux, and it only worked sporadically on Windows when I used that, but I never saw this particular problem there...).
I've only been able to find a paucity of information about this (or any) printer under Linux/CentOS - I've used lpstat, the (gnome) printer administration tool, and occasionally the CUPS interface - what am I looking for so that I can tell what/how to change it?
Well I think printer status is communicated through hal/dbus and cups, but if the printer blinks red that's a sure sign that things are not good.
-Ross
______________________________________________________________________ This e-mail, and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail, you are hereby notified that any dissemination, distribution or copying of this e-mail, and any attachments thereto, is strictly prohibited. If you have received this e-mail in error, please immediately notify the sender and permanently delete the original and any copy or printout thereof.