mcclnx mcc wrote:
setup IP address as "192.168.xxx.xxx" does NOT work. Someone say I need use "crossover" type of cable, but I don't have. I put a switch and coneect cable from each PC and it work fine.
Crossover cables or crossover connectors (those little white connectors that can be used to connect two RJ45 cables together) can be had at any 'serious' PC store. Also online from many many sites.
I always carry a crossover cable in my travel bag.
Thanks.
--- gnulinux gnulinux@comcast.net 說：
mcclnx mcc wrote:
I have two DELL servers with two Ethernet ports in
it.
Bith servers have CENTOS 4.5 installed. First Ethernet port connect to public Ethernet line and
work
correctly. Second Ethernet port I connect point-to-point as private Ethernet (cable direct connect without router or switch). Private
Ethernet
use IP asddress 1.1.1.1 and 1.1.1.2.
I check "ifconfig -a" and both eth0 and eth1 are
up
and active. when I tried to ping another server
use
second port (private) and no response. Does
anything
I configure wrong?
Thanks.
======== info ===
%ifconfig -a eth0 Link encap:Ethernet HWaddr 00:08:74:EA:54:64 inet addr:172.29.86.15
Bcast:172.29.85.255
Mask:255.255.255.0 inet6 addr: fe80::208:74ff:feea:5464/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500
Metric:1 RX packets:471 errors:0 dropped:0
overruns:0
frame:0 TX packets:91 errors:0 dropped:0
overruns:0
carrier:0 collisions:0 txqueuelen:0 RX bytes:65669 (64.1 KiB) TX
bytes:11847
(11.5 KiB)
eth1 Link encap:Ethernet HWaddr 00:0E:2E:C8:B9:80 inet addr:1.1.1.1 Bcast:1.1.1.255 Mask:255.255.255.0 UP BROADCAST MULTICAST MTU:1500
Metric:1
RX packets:0 errors:0 dropped:0overruns:0
frame:0 TX packets:0 errors:0 dropped:0
overruns:0
carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) Interrupt:18 Base address:0x4c00
%ping 1.1.1.2 PING 1.1.1.2 (1.1.1.2) 56(84) bytes of data.
From 1.1.1.1 icmp_seq=1 Destination Host
Unreachable
From 1.1.1.1 icmp_seq=2 Destination Host
Unreachable
From 1.1.1.1 icmp_seq=3 Destination Host
Unreachable
--- 1.1.1.2 ping statistics --- 4 packets transmitted, 0 received, +3 errors, 100% packet loss, time 3015ms , pipe 3
%telnet 1.1.1.2 Trying 1.1.1.2... telnet: connect to address 1.1.1.2: No route to
host
Try a private network IP 192.168.xxx.xxx? Right ether cable, straight? _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
____________________________________________________________________________________設定安全圖章，保護您的 Yahoo!奇摩帳號不被駭客盜用！ http://tw.info.yahoo.com/seal/index.html _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos