When I try to start the ups daemon, I get the below error:
ups failed. The error was: Starting UPS driver controller: [FAILED]
Starting upsd: [FAILED]
Starting UPS monitor (master): [FAILED]
I have never used NUT before, I just knew it existed. Apcupsd has always done what I need but I would check the logs, I have no doubt they would show what is wrong. Have made any initial config? Check http://eu1.networkupstools.org/doc/2.2.0/README.html Read the FAQ: Once the config files are ready, start upsd: # /usr/local/ups/sbin/upsd -u nutsrv Check your syslog
If I can't get apcupsd or nut configured properly, then I will try the WinPower software the UPS manufacturer (and many others) specify.
Look here: http://www.apcupsd.com And here is a possible config: http://www.apcupsd.com/manual/Configuration_Examples.html#SECTION00013300000...
I have the tar ball on my hard drive (45.3 MB) and maybe I can "roll my own" RPM for the first time.
You need to write a spec file, then use rpmbuild to make the rpm. Google should hopefully provide the guidance this needs, you can also ckeck the spec from any src.rpm file you can get by extracting the contents: rpm2cpio example.src.rpm | cpio -dimv The look for the spec.
jlc
Ps. My guess you:)